Switch Overview - Cisco Catalyst 6500 Series Configuration Manual

Catalyst 6500 series switch and cisco 7600 series router firewall services
Hide thumbs Also See for Catalyst 6500 Series:
Table of Contents

Advertisement

Configuring the Switch for the Firewall Services
Module
This chapter describes how to configure the Catalyst 6500 series switch or the Cisco 7600 series router
for use with the Firewall Services Module (FWSM). Before completing the procedures in this chapter,
configure the basic properties of your switch, including assigning VLANs to interfaces, according to the
documentation that came with your switch.
This chapter includes the following sections:

Switch Overview

You can install the FWSM in the Catalyst 6500 series switches or the Cisco 7600 series routers. The
configuration of both series is identical, and the series are referred to generically in this guide as the
"switch." The switch includes a switch (the supervisor engine) as well as a router (the Multilayer Switch
Feature Card (MSFC)).
The switch supports two software modes:
Both modes are described in this guide.
See the
For each FWSM in a switch using Cisco IOS software, the SPAN reflector feature is enabled. This
Note
feature enables multicast traffic (and other traffic that requires central rewrite engine) to be switched
when coming from the FWSM. The SPAN reflector feature uses one SPAN session. To disable this
feature, enter the following command:
Router(config)# no monitor session servicemodule
OL-6392-01
Switch Overview, page 2-1
Verifying the Module Installation, page 2-2
Assigning VLANs to the Firewall Services Module, page 2-2
Adding Switched Virtual Interfaces to the MSFC, page 2-5
Customizing the FWSM Internal Interface, page 2-11
Configuring the Switch for Failover, page 2-11
Managing the Firewall Services Module Boot Partitions, page 2-12
Cisco IOS software on both the switch supervisor engine and the integrated MSFC router.
Catalyst operating system software on the supervisor engine, and Cisco IOS software on the MSFC.
"Using the MSFC" section on page 1-10
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
C H A P T E R
for more information about the MSFC.
2
2-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

7600 series

Table of Contents