Cisco Catalyst 6500 Series Configuration Manual page 298

Verifying the Failover Configuration
Table 15-2
Table 15-2 Show Failover Display Description
Field
Failover
Failover module
Failover LAN Interface
Module Poll frequency
Interface Poll frequency
Interface Policy
Monitored Interfaces
Config sync
Last Failover
This host:
Other host:
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
15-20
General 0
sys cmd 0
up time 0
xlate 0
tcp conn 0
udp conn 0
ARP tbl 0
RIP Tbl 0
Logical Update Queue Information
Cur
Recv Q: 0
Xmit Q: 0
describes the show failover output.
Options
•
•
•
•
Shows the interface name and VLAN for the failover link:
interface_name vlan number
If you have not configured the failover interface, the display shows:
Not configured
n seconds
The number of seconds you set with the failover poll unit command.
The default is 15 seconds.
n seconds
The number of seconds you set with the failover poll interface
command. The default is 15 seconds.
n[%]
The threshold for interface failure that you set with the failover
interface-policy command. The default is 50%.
n of 250 maximum
The number of interfaces you are monitoring.
•
•
The last time a failover occurred.
For each host, the display shows the following information.
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
Max Total
0 0
0 0
On
Off
Primary
Secondary
Active—Configuration synchronization is active on the FWSM
Suspended—Configuration synchronization has been suspended or
disabled on the FWSM
Chapter 15 Using Failover
0
0
0
0
0
0
0
0
OL-6392-01