Cisco Catalyst 6500 Series Configuration Manual page 129

Chapter 8 Configuring IP Addresses, Routing, and DHCP
To match any routes that have a specified metric, enter the following command:
•
FWSM(config-route-map)# match metric metric_value
The metric_value can be from 0 to 4294967295.
To match any routes that have a next hop router address that matches a standard ACL, enter the
•
following command:
FWSM(config-route-map)# match ip next-hop acl_id [ acl_id ] [...]
See the
If you specify more than one ACL, then the route can match any of the ACLs.
To match any routes with the specified next hop interface, enter the following command:
•
FWSM(config-route-map)# match interface vlan number [vlan number ]
If you specify more than one interface, then the route can match either interface.
• To match any routes that have been advertised by routers that match a standard ACL, enter the
following command:
FWSM(config-route-map)# match ip route-source acl_id [ acl_id ] [...]
See the
If you specify more than one ACL, then the route can match any of the ACLs.
• To match the route type, enter the following command:
FWSM(config-route-map)# match route-type {internal | external [type-1 | type-2]}
Enter one or more set commands.
Step 3
If a route matches the match commands, then the following set commands determine the action to
perform on the route before redistributing it.
To set the metric, enter the following command:
•
FWSM(config-route-map)# set metric metric_value
The metric_value can be a value between 0 and 294967295
To set the metric type, enter the following command:
•
FWSM(config-route-map)# set metric-type {type-1 | type-2}
To set the next hop router IP address, enter the following command:
•
FWSM(config-route-map)# set ip next-hop ip_address [ ip_address ] [...]
The next hop must be an adjacent router. If you specify more than one address, if the interface
associated with the first next hop address is down, then the next address is used.
The following example redistributes routes with a hop count equal to 1. The FWSM redistributes these
routes as external link-state advertisements (LSAs) with a metric of 5, metric type of Type 1, and a tag
equal to 1.
FWSM(config)# route-map 1-to-2 permit
FWSM(config-route-map)# match metric 1
FWSM(config-route-map)# set metric 5
FWSM(config-route-map)# set metric-type type-1
OL-6392-01
"Adding a Standard Access Control List" section on page 10-17
"Adding a Standard Access Control List" section on page 10-17
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
Configuring OSPF
to add the standard ACL.
to add the standard ACL.
8-7