Types Concerned; Summary; Dcs600 Multidrive - How To Download Parameter Files On A Sdcs-Amc-Dc X Board - ABB DCS 500B Service Manual

DCS600 MultiDrive - How to download
parameter files on a SDCS-AMC-DC x
board
Types concerned DCS600 MultiDrive

Summary

Reload DCS600
MultiDrive pa-
rameters
DCS 500 / DCS 600 Service Manual
Procedure how to download parameter files on a SDCS-AMC-DC x.
Note: This procedure should be used for new or newly loaded
SDCS-AMC-DC x boards.
An actual parameter set of all drives should be always available. If
this is not the case, please create actual parameter sets by means
of DriveWindow and save them as *.DWP files. For DCS 600 Mul-
tiDrive a backup is not necessary, because the firmware is the
same for all sizes and the autotuning results are saved as parame-
ters.
1. Install and reconnect the new or newly loaded SDCS-AMC-DC x
board in the DCS600 MultiDrive.
2. If a DriveWindow network is existing do not connect the
DCS600 MultiDrive with the network. When using a new or
newly loaded board parameter 70.15 (CH3 NODE ADDR) is set
to 1 by default. This leads to a conflict in case another drive in
the network owns node number 1.
3. Connect the DCS600 MultiDrive with the new or newly loaded
SDCS-AMC-DC x board directly with DriveWindow.
4. Download the actual parameter set.
Note: Group 99 will not be downloaded and has to be set by
hand.
5. To activate parameters 70.15 (CH3 NODE ADDR) and 97.01
(DEVICE NAME) deenergise and energize the DCS600 Mul-
tiDrive.
6. Check the downloaded parameters with the DriveWindow com-
pare function.
7. As soon as parameter 70.15 is valid it is possible to connect the
DCS600 MultiDrive again with the DriveWindow network.
8. Set parameters in group 99 back to desired values.
Note: User macros have to be created manually by means of
parameters 95.11 (APPLICATION MACRO) and 99.09 (APPLIC
RESTORE).
3ADW000093R0701_DCS500B/DCS600_Service manual_e_g
Chapter 10 - Service
VI A
10 - 25