Preparation - ABB DCS 500B Service Manual
Dcs thyristor power converters
for dc drive systems
25 to 5200 a
Hide thumbs
Also See for DCS 500B:
- Operating instructions manual (76 pages) ,
- Description (228 pages) ,
- Service manual (73 pages)
Table of Contents
Advertisement
Chapter 10 - Service
Preparation
VI A
10 - 12
To finish installation press proceed.
•
Switch off auxiliary supply voltage of SDCS-POW-1.
•
Disconnect and remove SDCS-AMC x board (only
DCS 600).
•
Disconnect any other equipment from X33 and X34.
•
Connect bus cable from NPCU-02 to X33 or X34 at DCS con-
verter.
•
Connect the interface NPCU-02 to COM1 at the PC.
•
Set Jumper S2 on SDCS-CON-x from position 7-8 or 3-4 to 5-6.
•
Copy the files distributed from ABB
into designated pathes e.g.
C:\Program Files\Windows NT\HyperTerminal and
C:\...\DCSx00
•
Start HyperTerminal Private Edition by double-click on CON2
download.ht.
This setup file configures HyperTerminal Private Editon to commu-
nicate with the SDCS-CON-x board.
3ADW000093R0701_DCS500B/DCS600_Service manual_e_g
(see Software
DCS 500 / DCS 600 Service Manual
configuration)
Advertisement
Table of Contents
