Dcs600 Multidrive - How To Download Firmware On A Sdcs-Amc-Dc 2 Board Under Windows Nt 4.0; Types Concerned; Summary; Installation Of Ntnisa Drivers - ABB DCS 500B Service Manual

DCS600 MultiDrive - How to download
firmware on a SDCS-AMC-DC 2 board
under Windows NT 4.0
Types concerned DCS600 MultiDrive

Summary

Download firm-
ware with
PCMCIA card
(notebook or
desktop)
Installation of
NtNisa drivers
DCS 500 / DCS 600 Service Manual
Installation of NtNisa drivers and instruction how to download firm-
ware on a SDCS-AMC-DC 2 board under Windows NT 4.0. This
download procedure is only valid for the basic firmware (AMC
15.6xx) from Lamperteim and not suitable for any application soft-
ware.
In order to use the loading package under Windows NT, install
DriveWindow version 1.xx first. Afterwards the NT I/O handling has
to be released.
The first step is to find the used I/O addresses (280h - 340h) for the
PCMCIA card (NDPA-02). The second is to reconfigure the I/O
handling of NT.
Note: If You already done so go directly to:
tiDrive firmware!
Following programs and files are required (Put them all in the direc-
tory where the unzipped load package is located. All files are alrea-
dy available in the firmware load package dc15x620 or higher):
ntnisa.exe
nisareg.exe
nisadump.exe (to monitor the I/O addresses)
ntvddb.dll
The DOS prompt has to be set to full screen. To do that You have
to right click the DOS prompt icon (Attention: the DOS prompt icon
has to be on the desktop of your PC). Go to properties, options and
set display options to full screen.
To continue You have to be an ADMINISTRATOR on Your own
PC!!!
3ADW000093R0701_DCS500B/DCS600_Service manual_e_g
(to release the I/O control for DOS - programs)
(to set the I/O base address and make the
pcmcia.inf file)
Chapter 10 - Service
Download DCS600 Mul-
VI A
10 - 23