Install New Thyristor Modules - ABB DCS 500B Service Manual

Chapter 4 - Exchange of Thyristors for Sizes C1/C2/C2b
Install new thyristor
modules
VI A
4 - 2
- Remove old thermal joint compound (grease) from the heat sink.
Preparation of the heat sink: if the area is clean, spread out the
heat-conducting compound with a rubber spatula or by hand. If
the area is dirty, clean the heat sink surface with tissue paper.
Clean the mounting surfaces with an appropriate solvent (e.g.
ethanol).
- Apply a thin coat of thermal joint compound to the new module.
Spread the thermal joint compound evenly by moving the module
forward and backward on the heat sink.
- Tighten the clamping screws by hand until the screw heads
touch the bottom of the module. Then tighten the screws to 2.5
Nm torque. If the module is mounted using four screws, tighten
the screws crosswise.
- Tighten the screws to nominal torque (see Table below).
- Reinstall the busbars; make sure, the correct torque is applied
and reconnect all cables.
Thyristor module
Size (width) Type
20 mm block SKKT.....
20 mm block MCC 95-16io1B
34 mm block SKKT.....
34 mm block TT.....
50 mm block SKKT.....
50 mm block TT.....
50 mm block SKET.....
(single thyrist.)
50 mm block TZ.....
(single thyrist.)
60 mm block TT425/TT570
Table 4-1 Nominal mounting torques for thyristor modules
3ADW000093R0701_DCS500B/DCS600_Service manual_e_g
Nominal mounting torques
Electrical Module to
connections heat sink
3 Nm
3 Nm
5 Nm
6 Nm
9 Nm
12 Nm
9 Nm
12 Nm
12 Nm
DCS 500 / DCS 600 Service Manual
5 Nm
3 Nm
5 Nm
6 Nm
5 Nm
6 Nm
5 Nm
6 Nm
6 Nm