Cleaning The Oven Door - AEG BE5013001 User Manual

28 www.aeg.com/au

10.4 Cleaning the oven door

Removing the door and the glass panels
You can remove the oven door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove the
door from the appliance. The
door is heavy.
2
B
Installing the door and the
glass panels
When the cleaning is completed, install
the glass panels and the oven door. Do
A
A
1
1. Open the door fully.
2. Fully press the clamping levers (A)
on the two door hinges.
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on
each side and pull it away from the
appliance at an up angle.
5. Put the door with the outer side
down on a soft cloth on a stable sur-
face. This is to prevent scratches.
6. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
7. Pull the door trim to the front to re-
move it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9. Clean the glass panel with water
and soap. Dry the glass panel care-
fully.
the above steps in the opposite se-
quence. Install the smaller panel first,
then the larger.