JUMO mTRON T Manual page 9

7050XX00T90... (B 7050XX.0)
Operating manual
The operating manuals of the individual modules contain all information on installation, electri-
cal connection, startup, operation, and – if required – parameterization and configuration.
7050XX0XT92... (B 7050XX.2.X)
Interface description
The interface description provides information about the use of that interface and on commu-
nication with other devices, superordinate systems or certain sensors.
7050XX00T94... (B 7050XX.4)
Installation instructions
The installation instructions describe the installation of the device and the connection of the
supply and signal cables. The instructions also contain a list of the technical data.
7050XX5XT90... (B 7050XX.5.X)
Operating manual (application)
The operating manual describes the use of a certain application (e. g. PLC application).
1.2.3 Documentation for optional software
The manuals specified below are available on the Internet as PDF files. They also form part of
the scope of delivery of the respective software.
70500000T96... (B 705000.6)
Setup program
The manual describes the function of the setup program.
70970100T90... (B 709701.0)
PC evaluation software PCA3000
The operating manual describes the operation and the features of the PC evaluation software.
The PC evaluation software helps to visualize and evaluate the recorded process data (mea-
surement data, batch data, messages, etc.).
70970200T90... (B 709702.0)
PCA communication software PCC
The operating manual describes the operation and the features of the PCA communication
software. The PCA communication software is responsible for the data transfer from a device
or system to a PC or to a network.
70075500T90... (B 700755.0)
Plant visualization software SVS3000
The operating manual describes the operation and features of the plant visualization software.
The plant visualization software is responsible for networking interface-ready process devices
with a PC.
1 Introduction
9