JUMO mTRON T Manual page 45

Error code
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
Error list: interface processing
47
48
49
50
51
52
53
54
55
Error list: event processing
60
61
62
63
64
65
66
Error list: message processing
70
71
3 Modbus protocol description
Description
Edit is inadmissible when the program is active
Copy is inadmissible when the program is active
MANUAL is inadmissible during AUTO lead time
Segment change Image update required
No DB number, image update by PLC
No DB number for process values of PLC
Printer loaded or not operational
Setpoint value 1 was not programmed
Configure printer (config./interface)
Only possible, when the device is in MANUAL mode
Self-optimization already running
Time axis elapsed or not programmed
Time axis cannot be copied
Time axis not available
Program change is locked
MANUAL mode locked
Program start locked
Incorrect response length
Time-out error (no response)
Error reported in telegram protocol
Checksum error
Parity error
Framing error
Interface buffer full
Address error (e.g. address does not exist)
Incorrect or unexpected command
event could not be created
event setting failed
event clear failed
event wait failed
event close failed
event open failed
Sync error between group and data manager
Queue memory does not exist
Message queue cannot be opened
45