Network (Tcp/Ip) Settings - Kyocera KM-2550 Operation Manual

Network (TCP/IP) settings

This section explains the procedures to set the network address for the scanner.
Notes
•
•
1 Press the System Menu/Counter key to display the
Default setting screen.
2 Use the
default and then press the Enter key. The password
entry screen will appear.
Enter the password with Numeric keys. The password
3
at the factory default setting is 1600 for the 16 ppm
model, 2000 for the 20 ppm model and 2500 for the 25
ppm model.
Notes
•
•
Use the
4
then press the Enter key. Screen will change to the
DHCP/BOOTP setting screen.
Use the
5
and then press the Enter key. Screen will return to the
Scanner setting screen of Step 4.
Note If you are using a DHCP server, select 2 On. In this case, even if you enter each IP address and
subnet mask manually, the entered settings will be ignored.
Use the
6
address and then press the Enter key. Screen will
change to the IP address setting screen.
7 Enter the IP address by every three digits with Numeric
keys. Press > key to move to the following three digits.
Check the entered IP address and then press the
Enter key if it is correct. Screen will return to the
Scanner setting screen of Step 6.
The network address that should be set here will differ depending upon your network
environment. Check with your network administrator BEFORE performing this setting.
If you are using a DHCP server to set the network addresses, you will not need to change the
IP address and the subnet mask because the DHCP has been enabled (ON) as the factory
default setting.
and keys to move
If the password matches, the screen will change to the Scanner setting screen.
Four-digit password can be changed. Refer to the Operetion Guide of machine.
and keys to move
and keys to move
and keys to move
to select Scan
Default setting / Counter
Enter Pin Code using # key.
to select DHCP and
Scan Default:
to select 1 Off
DHCP/BOOTP
to select IP
Scan Default:
IP Address
Copy default
Machine default
Scan default
Subnet : 255.255.255. 0
Gateway : 10. 181. 12.11
DHCP/BOOTP : On
Off
>
On
IP Address : 10. 181. 15. 11
Subnet : 255. 255. 255. 0
Gateway : 10. 181. 12. 11
10 . 181 . 15 .
Set-up
11
2-3