Ricoh SP C340DN User Manual page 77

Message
"Hardware Problem: HDD"
"Hardware Problem:
Parallel I/F"
"Hardware Problem: USB"
Cause
An error has occurred in the hard
disk.
An error has occurred in the IEEE
1284 interface board.
An error has occurred in the USB
interface.
When Messages Are Displayed
Solution
• Turn the main power switch
off and then back on again.
If the message appears
again, contact your service
representative.
• The hard disk may have not
been installed properly if
you have installed it yourself.
Check that it is properly
installed For details about
installing the unit, see
"Installing the Hard Disk",
Operating Instructions.
• Turn the main power switch
off and then confirm the IEEE
1284 interface board is
inserted correctly. For details
about installing the board,
see "Installing the Interface
Units", Operating
Instructions.
• If the message appears
again, contact your service
representative.
Turn the main power switch off
and then back on again. If the
message appears again, contact
your service representative.
75