Ricoh SP C340DN User Manual page 72

3. Troubleshooting
Message
"Check network settings.
(103/203)"
"Classification Code Error"
"Connect
failed:WirelessCard Turn
power off, check card."
"Cover Open. Please close
the indicated cover."
"Duplex mode is in off
position for (tray name)"
"ECO Night Sensor did not
turn Power Switch off. Turn
switch off manually or to
use, press any key."
"Ethernet Board Error"
"Failed to connect to server
for Remote Diagnostics."
"IPv6 Address already exists
Link-local
Address(109/209)"
"IPv6 Address already exists
Stateless
Address(109/209)"
70
Cause
The IP address setting is incorrect.
A classification code is not
specified for the print job.
The printer cannot detect the
wireless LAN interface board.
A cover of the printer is open.
The duplex mode for the indicated
tray is not available.
Auto power off by the [ECO
Night Sensor] function failed.
An error on the Ethernet is
detected.
The printer cannot communicate
with Remote Communication
Gate.
The same IPv6 address is already
used.
The same IPv6 address is already
used.
Solution
Check the IP address, subnet
mask, and gateway address.
Enter a classification code using
the printer properties and print the
document again.
Check that the board is supported
or installed correctly.
Close the cover as indicated on
the control panel.
You can use one-sided printing
only. Press [Change] to change
the tray's settings, press [JobReset]
to reset the job, or press [Form
Feed] to force printing.
Turn off the power manually, or
press any key to use [ECO Night
Sensor] auto power off function.
Turn the printer off, and then turn it
on again. If the problem persists,
contact your sales or service
representative.
Check the connection to the
Remote Server Gate.
Contact your network
administrator.
Contact your network
administrator.