Remote Operation; Operating From A Remote Location - Panasonic KX-FP121 Operating Instructions Manual

Operating from a remote location

The following operations can be performed from a remote location using a touch tone telephone.
Set the unit to the TAD/FAX mode before going out (p. 84).
Dial Key Remote command
Skips the greeting message
0
1 Repeats a message
2 Skips a message
4
New message playback
5
All message playback
6
Room monitor
7
Re-records a greeting message
Stops re-recording of a greeting
9
message
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
Page Dial Key
97 Erases a specific message
4
95 Erases all messages
5
95 Changes to the TEL mode
8 0
Turns ON message transfer for
95
8 1
incoming messages
95
Turns OFF message transfer for
8 2
incoming messages
96
Turns ON pager call for incoming
8 3
96
messages
Turns OFF pager call for
8 4
96
incoming messages
Answering Device

Remote Operation

1. Call your unit.
2. Enter the remote operation ID
during the greeting
message.
The new recorded
messages will be played
automatically.
3. Press the remote command
key(s) (see the reverse side)
within 10 seconds.
If there are no new messages,
press the remote command
key(s) within 4 seconds.
or
Wait for 4 seconds, and all the
recorded messages will be
played back.
Remote Operation
Remote command
Notice of Remote Operation
The remote operation is
available only from a touch
tone telephone when the unit
is in the TAD/FAX mode.
When the unit is in the TEL
mode, call your unit and wait
for 15 rings. The answering
device will temporarily answer
the line. Enter the remote
operation ID during the
greeting message. The unit will
switch to the TAD/FAX mode.
When you press any key,
press firmly.
To send a document, press
. When a fax tone is
9
heard, start transmission.
Page
96
96
97
97
97
97
97
93