Table of Contents
Advertisement
Operating from a remote
The following operations can be performed from a remote location using a touch tone telephone.
Program the remote operation ID (p. 66) and set the unit to the TAD/FAX mode before
going out (p. 56).
Dial Key
Remote command
Skips the greeting message
0
Repeats a message
1
Skips a message
2
New message playback
4
All message playback
5
Room monitor
6
Re-records a greeting message
7
Stops re-recording of a
9
greeting message
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
location!
Page
Dial Key
69
67
67
67
67
68
68
68
Answering Device
Remote Operation
1. Call your unit.
2. Enter the remote operation ID
during the greeting
message.
The new recorded
messages will be played
automatically.
3. Press the remote command
key(s) (see the reverse side)
within 10 seconds.
If there are no new messages
in step 2, press the remote
command key(s) within 4
seconds or wait for 4
seconds, and all the recorded
messages will be played back.
Remote Operation
Remote command
Erases a specific message
4
Erases all messages
5
Changes to the TEL mode
8 0
Turns ON message transfer for
8 1
incoming messages
Turns OFF message transfer for
8 2
incoming messages.
Turns ON pager call for incoming
8 3
messages
Turns OFF pager call for incoming
8 4
messages.
Notice of Remote Operation
The remote operation is
available only from a touch
tone telephone when the unit
is in the TAD/FAX mode.
When the unit is in the TEL
mode, call your unit and wait
for 15 rings. The answering
device will temporarily answer
the line. Enter the remote
operation ID during the
greeting message. The unit will
switch to the TAD/FAX mode.
When you press a key, press
firmly.
To send a document, press
. When a fax tone is
9
heard, start transmission.
Page
68
68
69
69
69
69
69
65
Advertisement
Table of Contents
