4. Set up the rest of the Sub Servers by entering their IP addresses, and please note that the
Sub Servers must be adjacent to one another on the layout, or it won't work.
Figure 6-9
5. Click Save to save the setting.
For the Sub Server:
1. Select Sub Server in the Mode drop-down list, and check the Enable box.
2. Enter the IP address of the Main Server, and click Save.
3. When the message pops up as below, the eZ Hopper function is enabled. So, you can now
use the mouse connected to the Main Server to control this Sub Server's OSD.
Figure 6-10
76
PARAGON960 x4 32CH