Ilo Addresses; Ilo Ipv4 Address Requirements; Ilo Address Worksheet; Default User Names And Passwords - HP Hyper Converged 380 Installation Manual

iLO addresses

iLO IPv4 address requirements

Each HC380 server has an iLO which is manually configured with an IPv4 address on the ESX
management network. HC380 Management UI imports the iLO for each of the servers by IP address
during its configuration process, so that it can then manage the iLOs.
HC380 Management UI does not require that you enter the serial number, but it does associate each IP
address to a serial number. All of the iLO IP addresses must be accessible from the ESXi management
network.
For more information about iLO, see "HPE iLO 4 (on page 13)."

iLO address worksheet

Use the worksheet to record the node serial number and the iLO IP address associated to that serial
number.
During an expansion, you can use this same worksheet and then manually enter the IPv4 addresses into
HC380 Management UI (Settings area) for each new node that you are adding.
Node Serial number
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16

Default user names and passwords

The following default usernames and passwords are shipped with the appliance or are needed to
complete the setup.
iLO IP address
Preinstallation worksheets 17