Installing Nvidia Grid Manager Software On Vsphere; Configuring The Hc380 Using Oneview Instanton; Guidelines For Using Oneview Instanton - HP Hyper Converged 380 Installation Manual

# gpumodeswitch --gpumode graphics
Type y to confirm updating all graphics adapters.
2.
Run the following command to reboot the vSphere host.
3.
# reboot
Verify that the GPU Mode is set to Graphics by running the following command:
4.
# gpumodeswitch --listgpumodes

Installing NVIDIA GRID Manager Software on vSphere

Obtain the nVIDIA GRID Manager software by visiting the NVIDIA website
1.
(http://www.nvidia.com/object/nvidia-grid-buy.html).
Extract the GPU configuration utility from NVIDIA-GRID-vSphere-6.0-361.45.09-362.56.zip.
2.
Copy the NVIDIA-vGPU-VMware_ESXi_6.0_Host_Driver_361.45.09-1OEM.600.0.0.2494585.vib
3.
to the root of the vSphere host.
From the vSphere host console (or SSH), run the following command to put the HC 380 node into
4.
Maintenance mode.
# esxcli system maintenanceMode set -e true -t 0
Run the following command to install the NVIDIA GRID manager software.
5.
# esxcli software vib install -v /
NVIDIA-vGPU-VMware_ESXi_6.0_Host_Driver_361.45.09-1OEM.600.0.0.2494585.v
ib
Run the following command to reboot the vSphere host.
6.
# reboot
Run the following command to remove the vSphere host from Maintenance mode.
7.
# esxcli system maintenanceMode set -e false -t 0
Run the following command to verify that NVIDIA GRID Tesla M60 graphics adapters are present
8.
and installed.
# nvidia-smi

Configuring the HC380 using OneView InstantOn

Guidelines for using OneView InstantOn

OneView InstantOn is the automated deployment tool that guides you through the steps to configure your
HC380 appliance. Following successful completion of this configuration, you then perform the initial
HC380 Management UI configuration before you can begin deploying virtual machines. After you add all
the configuration information in OneView InstantOn, you can deploy the system.
Use the following guidelines for using OneView InstantOn:
•
Before launching OneView InstantOn, verify that your management VM contains the folder
C:\ProgramData\Hewlett-Packard\StoreVirtual\InstantOn\PostDeployment. Contact Hewlett
Packard Enterprise Support if it does not.
•
While OneView InstantOn is running, do not run anything else on the system including running
Windows Update and configuring proxies.
•
Do not run OneView InstantOn while performing an HPE LeftHand OS upgrade.
•
OneView InstantOn allows you to perform initial deployments and expansions of existing
deployments. Following a successful deployment, you can launch the tool to expand the system or
view the settings, but you are not allowed to change the settings or redeploy the system.
Configuring the system 36