Uplink Into Existing Network Infrastructure; Configuration Worksheet - HP Hyper Converged 380 Installation Manual

received, 0.0% packet loss, round-trip min/avg/max/std-dev =
1.545/1.731/2.029/0.163 ms.
If the ping is successful, then that network switch is IPv6 enabled. Retry this same test on the
b.
next level switch if possible, all the way to the 1GbE switch until you are able to find the point in
the network IPv6 is disabled or blocked.
Ensure you remove the ipv6 link-local address on the switch if the network administrators do not
c.
want it enabled.
[HPE] interface Vlan-interface <<mgmt_net_vlan>>
[HPE-Vlan-interface] undo ipv6 address auto link-local
[HPE-Vlan-interface] quit

Uplink into existing network infrastructure

Depending on the available network infrastructure, several methods and features can be used to uplink
the HPE 5900AF-48XG-4QSFP+ or Cisco Nexus 5672UP switches configured above to an existing
network infrastructure. Hewlett Packard Enterprise recommends using bridge aggregations (HPE) or
virtual port channels (Cisco) to uplink the switches into the infrastructure. More information can be located
in HP 5920 & 5900 Layer 2 - LAN Switching Configuration Guide or Cisco Nexus 5600 Series NX-OS
Interfaces Configuration Guide, Release 7.x.

Configuration worksheet

The configuration worksheet contains a list of values that are required to complete this deployment guide.
Before beginning deployment of a HC380, ensure the configuration worksheet is completed with the
correct and validated values by the customer. You are free to expand the example configuration
worksheet as needed to suite your needs.
Global Networking
Description
Management Network VLAN <<mgmt_net_vlan>>
Management Network
Netmask
Management Network
Gateway
Management Network NTP
Server 1
vMotion Network VLAN
iSCSI Network VLAN
VM Production Network
VLAN
Network Switches
Description
Network Switch 1
Management IP
Network Switch 2
Management IP
Network Switch 1 Hostname <<net_switch1_hostname>>
Network Switch 2 Hostname <<net_switch2_hostname>>
Network Switch Admin
Password
Variable
<<mgmt_net_netmask>>
<<mgmt_net_gw>>
<<mgmt_net_ntp1>>
<<vmotion_net_vlan>>
<<iscsi_net_vlan>>
<<vm_production_net_1_vlan
>>
Variable
<<net_switch1_mgmt_ip>>
<<net_switch2_mgmt_ip>>
<<net_switch_admin_passwo
rd>>
Value
Value
Appendix A: Network switch configuration 100