Could Not Create Tenant And Provider Vlan Networks; Could Not Add Subnets To Networks; Could Not Create Router; Could Not Update To 9.02 - HP Hyper Converged 380 Installation Manual

Action
Running deploy a second time from the UI will usually fix most problems. For more information, see
"Tenant and provider networking (on page 61)."

Could not create Tenant and Provider VLAN Networks

Symptom
Could not create Tenant and Provider VLAN Networks.
Explanation
The installer is creating the Tenant and Provider VLAN networks specified in the UI. Potential problems
could be that Tenant segment ranges were not created or all OpenStack services are not running. Other
setup problems could occur if the VLAN is not valid.
Action
Re-run the CloudSystem installation utility or refer to "Tenant and provider networking (on page 61)."

Could not add Subnets to Networks

Symptom
Could not add subnets to networks.
Explanation
The installer is attempting to create a subnet for a given VLAN from the CIDR specified in the user
interface. Potential causes could be that the VLAN does not exist or the CIDR overlaps with another
network.
Action
For more information, see "Tenant and provider networking (on page 61)."

Could not create router

Symptom
Could not create router.
Explanation
The installer is attempting to create a router in CloudSystem based on any Tenant, Provider, and External
networks specified in the user interface. It will only run once, so any new networks or changes will have to
be manually updated.
Action
For more information, see "Create router (on page 63)."

Could not update to 9.02

Symptom
Could not update to CloudSystem 9.02.
Action
Perform one or both of the following actions.
•
Run the program.
Troubleshooting 82