HP Hyper Converged 380 Installation Manual page 87

Press ctrl and c or ctrl and d to stop the automatic configurations.
2.
Whenever the instructions call for network configuration in "system view" context, if at the <HPE>
prompt, issue the system-view command to get to the [HPE] prompt.
Automatic configuration is aborted.
Line aux0 is available.Press ENTER to get started.<HPE> system-view
System View: return to User View with Ctrl+Z.
Configure the IRF ports.
3.
[HPE] interface range FortyGigE 1/0/51 to FortyGigE 1/0/52
[HPE-if-range] shutdown
[HPE-if-range] quit
[HPE] irf-port 1/1
[HPE-irf-port1/1] port group interface FortyGigE 1/0/51
[HPE-irf-port1/1] port group interface FortyGigE 1/0/52
[HPE-irf-port1/1] quit
[HPE]save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
HPE 5900AF-48XG-4QSFP+ Switch 1
To set up the initial configuration for the HPE 5900AF-48XG-4QSFP+ Switch 1 via the serial port,
complete the following steps:
Configure the switch.
1.
On initial boot and connection to the serial or console port of the switch, the Comware setup should
automatically start and attempt to enter Automatic configuration.
Automatic configuration attempt: 1.
Interface used: M-GigabitEthernet0/0/0.
Enable DHCP client on M-GigabitEthernet0/0/0.
Automatic configuration is running, press CTRL_C or CTRL_D to break.
Press ctrl and c or ctrl and d to stop the automatic configurations.
2.
Whenever the instructions call for network configuration in "system view" context, if at the <HPE>
prompt, issue the system-view command to get to the [HPE] prompt.
Automatic configuration is aborted.
Line aux0 is available.Press ENTER to get started.<HPE> system-view
System View: return to User View with Ctrl+Z.
Configure the IRF ports.
3.
[HPE] interface range FortyGigE 1/0/51 to FortyGigE 1/0/52
[HPE-if-range] shutdown
[HPE-if-range] quit
[HPE] irf-port 1/1
[HPE-irf-port1/1] port group interface FortyGigE 1/0/51
[HPE-irf-port1/1] port group interface FortyGigE 1/0/52
[HPE-irf-port1/1] quit
[HPE]save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Appendix A: Network switch configuration 87