HP Hyper Converged 380 Installation Manual page 94

Abort Power on Auto Provisioning and continue with normal setup? (yes/no)
[n]: yes
Enter the password for "admin": <<net_switch_admin_password>>
Confirm the password for "admin": <<net_switch_admin_password>>
Would you like to enter the basic configuration dialog (yes/no): yes
Create another login account (yes/no) [n]: Enter
Configure read-only SNMP community string (yes/no) [n]: Enter
Configure read-write SNMP community string (yes/no) [n]: Enter
Enter the switch name: <<net_switch2_hostname>>
Continue with Out-of-band (mgmt0) management configuration? (yes/no) [y]:
Enter
Mgmt0 IPv4 address: <<net_switch2_mgmt_ip>>
Mgmt0 IPv4 netmask: <<mgmt_net_netmask>>
Configure the default gateway? (yes/no) [y]: Enter
IPv4 address of the default gateway: <<mgmt_net_gw>>
Enable the telnet service? (yes/no) [n]: Enter
Enable the ssh service? (yes/no) [y]: Enter
Type of ssh key you would like to generate (dsa/rsa): rsa
Number of rsa key bits <768-2048>: 2048
Configure the ntp server? (yes/no) [n]: y
NTP server IPv4 address: <<mgmt_net_ntp1>>
Configure default interface layer (L3/L2) [L2]: Enter
Configure default switchport interface state (shut/noshut) [noshut]: shut
Enter basic FC configurations (yes/no) [n]: Enter
Would you like to edit the configuration? (yes/no) [n]: Enter
Review the configuration summary before enabling the configuration.
Use this configuration and save it? (yes/no) [y]: Enter
Configure global values
Complete this section on both Cisco Nexus 56128P switch 1 and Cisco Nexus 56128P switch 2.
Over the serial port on the switch, run the following commands in configure terminal mode to set up
default values for the solution.
switch# configure terminal
Enter configuration commands, one per line.
switch(config)# policy-map type network-qos jumbo
switch(config-pmap-nq)# class type network-qos class-default
switch(config-pmap-nq-c)# mtu 9216
switch(config-pmap-nq-c)# exit
switch(config-pmap-nq)# exit
switch(config)# system qos
switch(config-sys-qos)# service-policy type network-qos jumbo
snet02(config-sys-qos)# exit
switch(config)# copy running-config startup-config
Switch prompts are not displayed in the rest of the switch configuration in this section of the
documentation.
End with CNTL/Z.
Appendix A: Network switch configuration 94