The Power-On Self Test (Post) - Schenker N151RF1 User Manual

BIOS Utilities

BIOS Settings
Warning
Incorrect settings can
cause your system to
malfunction. To correct
5
mistakes, return to Set-
up and restore the Opti-
mized Defaults
<F3>.
UEFI Boot & POST
When UEFI Boot is en-
abled, then the prompts
to press F2 or F7 will
not appear. However
you can still press F2 to
enter the setup, or F7 to
choose the preferred
boot device, if you press
the key immediately the
system boots up.

5 - 2 The Power-On Self Test (POST)

The Power-On Self Test (POST)
If you enable the Boot-time Diagnostic Screen in the Setup Utility, each time you
turn on the computer the system takes a few seconds to conduct a POST, including
a quick test of the on-board RAM (memory).
As the POST proceeds, the computer will tell you if there is anything wrong. If there
is a problem that prevents the system from booting, it will display a system summary
and prompt you to run Setup.
with
If there are no problems, the Setup prompt will disappear and the system will load
the operating system. Once that starts, you can't get into Setup without rebooting.