Schenker N151RF1 User Manual page 53

3G/4G Module USIM Card Installation
(For Model A & B Computers Only)
Insert the USIM card
1
of the card as the gold contact side of the card should face downwards) until it clicks
fully into position. To eject the card simply press it until it ejects, but do not attempt
to eject the card while connected to a 3G/4G network (see below).
Simply press on the USIM card to eject it, however do not do this while a connection is in
progress. If you do eject the card while a 3G/4G connection is ongoing, you will need to shut
down the system, reinsert the USIM card, restart the system and then reestablish the 3G/4G
connection.
If you wish to change USIM cards then you will need to shut the system down, reinsert the
USIM card, restart the system and then reestablish the 3G/4G connection.
as illustrated below (pay careful attention to the orientation
Model B
Note that only Model B is pictured, however the card in-
1
sertion procedure for Model A is identical. Model C com-
puters do not support a 3G/4G module.

USIM Card Ejection
Quick Start Guide

USIM Card
Orientation
Note that the USIM
card's readable side
(with the gold-colored
contacts) should face
downwards as illustrat-
ed.
Figure 1 - 10
USIM Card Insertion
Right View 1 - 19
1