Schenker N151RF1 User Manual page 194

Troubleshooting
Problem
The computer feels too hot.
The system will not wake up from a
power saving state (Sleep/Hibernate)
7
on network activity (Wake on LAN) even
though I have plugged in the powered
AC/DC adapter.
No image appears on the external
monitor I have plugged in and powered
on.
7 - 8 Problems and Possible Solutions
Possible Cause - Solution
Make sure the computer is properly ventilated and the Vent/Fan intakes are not
blocked. If this doesn't cool it down, put the system into Hibernate mode or turn
it off for an hour. Make sure the computer isn't sitting on a thermal surface (see
"Overheating" on page 1 -
correct adapter.
Make sure that your notebook is completely powered off before putting it into a
travel bag (or any such container). Putting a notebook which is powered on in a
travel bag may cause the Vent/Fan intakes to be blocked.
Wake on LAN is supported in AC mode only.
When the system enters a power saving state the plugged in AC/DC adapter
should be connected, and should remain connected, in order to allow the
system to wake up on network activity. Unplugging the adapter, and then
plugging it back in again, will not allow the system to wake up on network
activity.
You haven't installed the video driver and configured it appropriately from the
Control Panel. See Appendix C
the video driver.
17, 1 - 22 & 1 - 24). Make sure you're using the
for instructions on installing and configuring