Optional Plumbing Procedures - Hague Quality Water Maximizer 400 Installation And Service Manual

I I n n s s t t a a l l l l a a t t i i o o n n S S t t e e p p s s a a n n d d S S t t a a r r t t - - U U p p P P r r o o c c e e d d u u r r e e s s
T T u u r r n n O O f f f f W W a a t t e e r r S S u u p p p p l l y y
STEP 2
A. Turn off the water supply.
B. Open the hot and cold water taps to depressurize the lines.
C C o o n n n n e e c c t t W W a a t t e e r r L L i i n n e e s s
STEP 3
A. Remove the valve cover.
1. Open the salt port lid on the valve cover and slide it down.
2. Place your fingertips on the bottom, inner edge of the
valve cover. (You may need to use two hands).
3. Squeeze the edge and pull the valve cover toward yourself
until it clicks free. (See Figure 4.)
4. Lift and remove the valve cover.
B. Qest fittings (Supplied with appliance with built-in bypass).
Qest connection fittings are provided with your appliance.
Qest fittings provide a convenient easy-to-use three-piece
assembly for 3/4-inch copper plumbing or 3/4-inch CTS
CPVC plastic tubing.
Ensure that the three components (1: collar, 2: metal
retaining ring, and 3: nylon sleeve) are correctly installed
in sequence on the pipe. See Figure 5.
C. Attach the water lines to the appliance in compliance
with all applicable building, plumbing, and electrical
codes. See Figure 6. Do NOT over tighten the
connections on the plastic threads.
Note: See Optional Plumbing Procedures for information
on copper fittings and joining plastic pipe.
D. Check the arrows on the valve to ensure that the water
flows in the proper direction.
Caution: Do NOT plumb your appliance in backward.
Figure 4: Remove Valve Cover
Figure 5: Qest Fitting Assembly
Figure 6: Connect Water Lines
(Appliance shown with optional bypass.)
7
2
1
3