Setting And Using The Controller - Hague Quality Water Maximizer 400 Installation And Service Manual

I I n n s s t t a a l l l l a a t t i i o o n n S S t t e e p p s s a a n n d d S S t t a a r r t t - - U U p p P P r r o o c c e e d d u u r r e e s s
P P l l u u g g i i n n t t h h e e T T r r a a n n s s f f o o r r m m e e r r
STEP 9
A. Plug the transformer into an appropriate outlet.
(See Figure 15.)
B. Ensure that the outlet selected is NOT operated
by an on/off switch.
STEP 10 S S e e t t U U p p t t h h e e C C o o n n t t r r o o l l l l e e r r
A. Program the appliance controller (See Figure 16.
Also see Setting and Using the Controller ).
F F l l u u s s h h A A p p p p l l i i a a n n c c e e
STEP 11
A. Open a cold water tap and allow the appliance to
flush for 10 minutes or until approximately 35
gallons (132 L) of water have passed through the
appliance per NSF requirements.
B. Verify water flow by checking the WaterMizer
(flashing light.)
STEP 12
A A d d d d W W a a t t e e r r t t o o t t h h e e B B r r i i n n e e T T a a n n k k
A. Remove any packaging or installation materials.
Do NOT remove the grid plate.
B. Add 1.5 gallons (5.7 litres) of water to the brine cabinet.
C. Ensure that the salt dosage is set as recommended for
the application. After the first regeneration, the appliance will
automatically refill the correct amount of water into the
brine tank.
D. Initiate a manual regeneration (See Setting and Using
the Controller ) and inspect for proper operation. Allow
the appliance to draw all the water out of the brine cabinet
until the air check sets.
E. Press the (R) button to advance to the Brine Refill
position (See Setting and Using the Controller ). Let
the tank fill with the proper amount of water. The
controller will then step the valve to the Home position.
Note: This initial start up is the ONLY time you will add water to the brine tank. Do NOT add water at
any other time.
Figure 15: Plugging in Transformer
10
Figure 16: Controller