Specifications - Hague Quality Water Maximizer 400 Installation And Service Manual

A A s s s s e e m m b b l l y y a a n n d d P P a a r r t t s s
D D r r a a i i n n E E n n d d C C a a p p A A s s s s e e m m b b l l y y
1
2
3
4
90268 Drain End Cap:
sealed with an O-ring used as axial or "face" seal. The O-ring sits in a groove in the End Cap. This groove must be
free of defects such as pits or scratches and also free of debris. When assembling the End Cap to the Valve Body,
care should be taken to make sure that the O-ring stays in the groove in the End Cap. If misaligned, the O-ring
can become pinched and leak.
H2086 Drain Line Flow Control:
minus 10%) backwash flow rate at varying pressures. Care should be taken when replacing FCs to ensure that
the correct rate is being used for a particular model. Refer to Specifications . When assembling the flow control,
ensure that the rounded side of the hole faces in toward the water flow.
H2086 - 2.4*
H2086 - 3.0*
90267 Retainer:
The Retainer (4) holds the backwash Flow Control in place. One side is smooth and the other
has a groove for a screw driver. When assembling the retainer to the Drain End Cap, the retainer should be
"screwed" in until it stops. If the retainer is not fully engaged, the Flow Control may not function properly.
*Must specify drain line flow control size. XX Indicates the back wash flow rate in gpm. Example: 90614-2.4
Figure 32: Drain End Cap Assembly
PART# DESCRIPTION
93808 O-Ring
90268 Drain End Cap
H2086-XX* Drain Line Flow Control
90267 Retainer
90614-XX* Entire Assembly (all the above parts)
The Drain End Cap (2) seals the left opening on the Main Valve Body. The opening is
The Drain Line Flow Control (D.L.F.C.) (3) maintains a constant (plus or
31
QUANTITY
1
1
1
1