Customer Settings - Hague Quality Water Maximizer 400 Installation And Service Manual

C C u u s s t t o o m m e e r r S S e e t t t t i i n n g g s s
To program Customer Settings, press and hold the P button for about 5 seconds while "CUSTOMER SETTINGS"
is displayed. Release the P button when Set Time is displayed.
S S e e t t T T i i m m e e o o f f D D a a y y
The display reads "Set Time" followed by the current time that is set. The cursor will be under the second hours
digit.
If the time displayed is correct, press P.
To Change the Time of Day
1. Press the C button repeatedly until the current hour is displayed. Make sure the time is correct with regard
to AM or PM.
2. Press S and the cursor moves to the right. Press the C button repeatedly until the current tens minute is
displayed.
3. Press S and the cursor moves to the right. Press the C button repeatedly until the current minute is
displayed.
4. When the desired time is displayed, press P. The Reg. Time is displayed.
S S e e t t R R e e g g e e n n e e r r a a t t i i o o n n T T i i m m e e
The display reads "Reg. Time" followed by the current regeneration time that is set. Usually you want to set a
regeneration time when water will not be used. The cursor will be under the second hours digit.
If the regeneration time displayed is correct, press P.
To Change the Regeneration Time
1. Follow the procedure outlined above for setting the time.
When the desired regeneration time is displayed, press P. The number of people is displayed.
S S e e t t N N u u m m b b e e r r o o f f P P e e o o p p l l e e ( ( M M o o d d e e 2 2 o o n n l l y y ) )
The display reads "# People" followed by the current setting for the number of people in the household. The cursor
will be under the tens digit.
If the number of people is correct, press P.
To Change the Number of People
1. Press the C button repeatedly until the desired value is displayed. Values will cycle from 0 to 9.
2. Press S and the cursor moves to the right. Press the C button repeatedly until the desired value is
displayed. Values will cycle from 0 to 9.
3. When the desired number of people are displayed, press P. The value is saved and the controller returns to
Normal operating mode.
Programming Customer Settings Is Now Complete
19