Checklist Before Installation - Hague Quality Water Maximizer 400 Installation And Service Manual

P P r r e e c c a a u u t t i i o o n n s s
D D o o
1. Comply with all local building, plumbing, and electrical codes.
2. Install before the water heater.
3. Install after the pressure tank on well-water installations.
4. Install a pressure-reducing valve if the inlet pressure exceeds 90 psi (6.2 bar).
5. Install a gravity drain on the cabinet.
6. Secure the drain line on the appliance and at the drain outlet. See Installation Steps and Start-Up
Procedures .
7. Allow a minimum of 8 to 10 feet (2.4 to 3.1 metres) of 3/4-inch pipe from the outlet of the appliance to the
inlet of the water heater.
D D o o N N o o t t
1. Do not install if checklist items are not satisfactory. See Checklist Before Installation .
2. Do not install if the incoming or outlet piping water temperature exceeds 120°F (49°C). See Specifications .
3. Do not allow soldering torch heat to be transferred to valve components or plastic parts.
4. Do not over tighten the plastic fittings.
5. Do not plumb the appliance against a wall that would prohibit access to plumbing. See Installation Steps
and Start-Up Procedures .
6. Do not install the appliance backward. Follow the arrows on the inlet and outlet. See Installation Steps and
Start-Up Procedures .
7. Do not plug the transformer into an outlet that is activated by an on/off switch.
8. Do not connect the drain and the overflow (gravity drain) together. See Installation Steps and Start-Up
Procedures .
9. Do not use to treat water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
Note: A bacteriostasis claim does not mean that these devices will make microbiologically unsafe water safe to
consume or use.
4