Service Settings - Hague Quality Water Maximizer 400 Installation And Service Manual

S S e e t t t t i i n n g g a a n n d d U U s s i i n n g g t t h h e e C C o o n n t t r r o o l l l l e e r r
In addition to the (R) Button, the controller has the following buttons that are used when programming Service
Settings and Customer Settings.
C C B B u u t t t t o o n n
The C, S, P, and (Scroll Back) buttons are used when changing Customer Settings and Service Settings.
The C button is used with the S button to set the value of certain parameters.
1. When you press the C button, the value under the cursor changes to the next available value,
typically increasing by one until all values have been displayed and the process begins again.
S S B B u u t t t t o o n n
The S button is used to move the cursor when setting parameters.
1. Press and release the S button to move the cursor one digit to the right of the parameter to be changed.
2. When the cursor is at the extreme right position, press the S button again to reset the cursor to the extreme
left position.
P P B B u u t t t t o o n n
The P button is used to enter programming modes and also to save a value and display the next value to be
changed.
1. To program Customer Settings, press and hold the P button for about 5 five seconds while
"CUSTOMER SETTING" is displayed.
2. To program Service Settings, press and hold both the P button and the S button while
"SERVICE SETTING" is displayed.
3. To reset the factory defaults, press and hold both the P button and the
seconds.
( ( S S c c r r o o l l l l B B a a c c k k ) ) B B u u t t t t o o n n
The button function is used to step back to a previous parameter setting. It is typically used to go back to correct
a setting without the need to scroll forward through all settings.
16
(scroll back) button for about five