Table of Contents
Advertisement
2.1
System Setup
You can easily get SPC started by following the below steps.
1.
Unpack the SPC package. Check the packing list at the beginning of this man-
ual to make sure all items have been included.
2.
Open side cover and then install 2.5" HDD in the HDD tray which contains Win-
dows Embedded Standard 7, Windows Embedded Standard 2009 or another
operating system. Then fix the side cover with screws, after that stopper the
screw hole with waterproof rubber.
SPC-xx81 User Manual
Figure 2.1 Unpack the Package
Figure 2.2 2.5" Hard Disk Drive
8
Advertisement
Table of Contents
Need help?
Do you have a question about the SPC-1881 and is the answer not in the manual?