Taking A Picture By Setting The Exposure Manually - Panasonic Lumix VQT2F10 Operating Instructions Manual

[REC] Mode:

Taking a picture by setting the exposure manually

Determine the exposure by manually setting the aperture value and the shutter speed.
Set the [REC]/[PLAYBACK] selector switch to [!], and then set the
mode dial to [
•
The Manual Exposure Assistance
Tilt the joystick towards 3/4/2/1 to set
the aperture value and the shutter speed.
B Aperture Value
C Shutter Speed
•
Focus can be set manually when [
(P83)
Press the shutter button halfway.
•
The Manual Exposure Assistance
about 10 seconds.
•
Set the aperture value and the shutter speed again
when the exposure is not adequate.
Take the picture.
∫ Manual Exposure Assistance
The exposure is adequate.
Set to faster shutter speed or larger aperture value.
Set to slower shutter speed or smaller aperture value.
•
The Manual Exposure Assistance is an approximation. We recommend checking the pictures
after taking them by using the review function.
Note
•
Refer to P82 for the available aperture values and the shutter speed.
•
The brightness of the LCD monitor/Viewfinder may differ from the brightness of the actual
pictures. Check the pictures using the Review function or Playback Mode.
•
If the exposure is not adequate, the aperture value and the shutter speed turn red when the
shutter button is pressed halfway.
•
[ ] for flash cannot be set.
Advanced (Recording pictures)
].
appears for about 10 seconds.
A
MF
] is displaying.
appears for
A
- 81 -
B C
A