Panasonic Lumix VQT2F10 Operating Instructions Manual page 197

Before cleaning the camera, remove the battery or disconnect the power plug from
the outlet. Then wipe the camera with a dry soft cloth.
•
When the camera is soiled badly, it can be cleaned by wiping the dirt off with a wrung wet cloth,
and then with a dry cloth.
•
Do not use solvents such as benzine, thinner, alcohol, kitchen detergents, etc., to clean the
camera, since it may deteriorate the external case or the coating may peel off.
•
When using a chemical cloth, be sure to follow the accompanying instructions.
•
Do not press the LCD monitor with excessive force. Uneven colors may appear on the LCD
monitor and it may malfunction.
•
If the camera is cold when you turn it on, the picture on the LCD monitor/Viewfinder will be
slightly darker than usual at first. However, the picture will return to normal brightness when the
internal temperature of the camera increases.
Extremely high precision technology is employed to produce the LCD monitor/
Viewfinder screen. However there may be some dark or bright spots (red, blue or
green) on the screen. This is not a malfunction. The LCD monitor/Viewfinder screen
has more than 99.99% effective pixels with a mere 0.01% of the pixels inactive or
always lit. The spots will not be recorded on pictures on the built-in memory or a card.
•
Do not press the lens with excessive force.
•
Do not leave the camera with the lens facing the sun as rays of light from the sun may cause it
to malfunction. Also, be careful when placing the camera outside or near a window.
•
When there is dirt (water, oil, and fingerprints, etc.) on the surface of the lens, the picture may
be affected. Lightly wipe the surface of the lens with a soft, dry cloth before and after taking
pictures.
Others
Cleaning
About the LCD monitor/Viewfinder
About the Lens
- 197 -