Panasonic Lumix VQT2F10 Operating Instructions Manual page 139

∫ About AF area selection
You can select the AF area by pressing [FOCUS] when [
selected.
It is also possible to switch to AF area selection screen by pressing 1 when AF Mode is
selected with 3/4.
•
You can set from the quick menu.
When selecting [ƒ], [Ø] or [Ù]
1
Press 3/4/2/1 to move the AF area.
•
You can set to arbitrary position of the
screen. (It cannot be set to edge of the
screen)
•
After moving the AF area, press [DISPLAY]
to return it to the center.
2
Press [MENU/SET] to set.
When selecting [
1
Press 3/4/2/1 to select AF
area as shown in the figure to the
right.
2
Press [MENU/SET] to set.
Note
•
AF area cannot be moved during motion picture recording.
•
The spot metering target can also be moved to match the AF area when using [Ù].
•
Position of the AF area will return to initial state when the camera is set to Intelligent Auto
Mode, When the Power Save Mode is activated, or When this unit is turned off.
Advanced (Recording pictures)
(P29)
]
ƒ Ø
- 139 -
], [ƒ], [Ø] or [Ù] is
Ù