GPS Tracker mp2 User Manual page 12

Personal gps tracker
Table of Contents

Advertisement

Gpstracker.net.in
Freedom is lost now...!
Geo-fence SMS to the SOS
preset number.
Extend Settings
Presetting by SMS for GPRS tracking (Ensure that your SIM card supports GPRS connection prior to setting)
Set ID for tracker
Set APN
Set IP Address and Port
Enable GPRS Tracking
Function
Set Time Interval for
Sending GPRS Packet
Note:1 to increase the call volume – just call the tracker , recive the call and press 1key to decrese and press 3 key to increase call volume
Note2 : to increase the ringer volume switchon the tracker press 3key for 3to 5 times and to decrease ringer volume press 1key for 3 to 5 times it becomes
mute
W000000,008,ABCDEFG
W000000,010,ID
W000000,011,APN,APN Name, APN
Password
W000000,012,37.59.232.31, 11200,
11200
W000000,013,X
W000000,014,XXXXX
=02, 50m
=03, 100m
=04, 200m
=05, 300m
=06, 500m
=07, 1000m
=08, 2000m
A=0, turn off the function of sending an
SMS location report to the authorized
phone number when it makes a call to tracker.
A=1, turn on the function of sending an
SMS location report to the authorized
phone number when it makes a call to tracker.
B=0, reserved
B=1, location data complies with NMEA 0183 GPRMC protocol.
For example:
$GPRMC,072414.000,V,3114.3763,N,
12131.3255,E,0.00,0.00,050805,*00
C=0, turn off the function to automatically hang up an incoming call.
C=1, turn on the function to automatically hang up an incoming call
after 4 - 5 rings.
D=0, Turn off the function of sending an SMS when tracker is turned on.
D=1, Turn on the function of sending an SMS to SOS number when
tracker is turned on.
E=0, reserved
E=1, tracker shuts down automatically
when the power voltage lower than 3V.
F=0, Turn off the alert when tracker
enters GPS blind area.
F=1, Turn on the alert when tracker
enters GPS blind area. SMS is to be
sent to SOS number
G=0, 3 LED lights work normally
G=1, 3 LED lights stop flashing when
tracker working.
(default value is: ABCDEFG=0100100 )
Tracker ID must not over 14 digits.
If no APN name and password
required, just insert APN only;
APN defaulted as 'airtelgprs';
APN+APN name + password not over 39 characters.
IP: xxx.xxx.xxx.xxx
Port: [1,65534]
X=0, turn off GPRS tracking (default);
X=1, enable TCP
XXXXX should be in five digitals and in unit of 10 seconds.
XXXXX=00000, to turn off this
function;
XXXXX=00001~65535, time interval for sending GPRS packet and in unit
of 10 seconds.

Advertisement

Table of Contents
loading

Table of Contents