GPS Tracker S911 Lola User Manual

Download this manual

Enlarged version

Knowing your S911 Lola

Power Button

Hold down for 3 seconds to turn ON or OFF the unit. GPS and GSM lights

will start flashing and the unit will vibrate.

Speaker & Microphone

Used for communication in case of emergency. For best call quality, hold

unit within 20cm of face.

GPS & GSM Indicators

These lights will show the connectivity status of GPS and GSM. Low battery

is indicated by a red LED flashing light.

Strap Hole

Loop the neck strap through this hole.

Micro USB Port

This port is used to charge and program the unit.

SOS Button & Back Light

To initiate an SOS call, hold down the SOS button for 3 seconds. The

backlight will begin to flash and your SOS call will begin.

Getting Started

1. Installing the MicroSim Card

Gently pull the rubber tab at the bottom of the unit

to open the Micro SIM card's bay.

Insert the pin into the small hole, pry and pull the

Micro SIM card's bay out.

Insert the Micro SIM card into the tray and slide

back into the unit. Close the rubber tab and you are

READY!

2. Charging the unit

The unit will by default turn ON whenever the USB

is plugged in. After plugging in the unit, the user can

turn OFF the unit to speed up the process. Full

charge can take up to 4 hours. When the battery is

low, the GSM LED indicator will flash red.

3. Installing LocationNow suite

Visit this site and download the LocationNow Suite:

http://www.laipac.com/lolaupdate.htm

Page 1: Getting Started
Getting Started Knowing your S911 Lola 1. Installing the MicroSim Card Gently pull the rubber tab at the bottom of the unit to open the Micro SIM card’s bay. Insert the pin into the small hole, pry and pull the Micro SIM card’s bay out.
Page 2 Hold the power button for 3 seconds to power off. Unit will vibrate and all *Important: The S911 Lola must be turned OFF prior to connecting lights will go off, indicating the unit has to your PC. If this step is not followed LocationNow Suite will not been shut down correctly.
Page 3 5. Setting up the unit and its features Accessing LocationNow.com “Networks”. The first step is to input 1. Login In: User ID and Password. the unit’s assigned ID. Here you will also input the details to connect your Now you need to enter your “User ID unit to the GSM Network and the and Password”.
Page 4 Using the LocationNow Suite……………………………………………………….…Page 2-3 Tampering or servicing the unit by any other than a qualified technician can lead to battery/unit damage 1. Connecting S911 Lola to LocationNow Suite. or personal injury. Always use OEM accessories and 2. Updating the unit’s firmware.