Transport And Installation - EWM Taurus 351 Basic FKG Operating Instructions Manual

Safety instructions

Transport and installation

2.4 Transport and installation
Risk of injury due to improper handling of shielding gas cylinders!
Improper handling and insufficient securing of shielding gas cylinders can cause
serious injuries!
•
Observe the instructions from the gas manufacturer and any relevant regulations
concerning the use of compressed air!
•
Do not attach any element to the shielding gas cylinder valve!
•
Prevent the shielding gas cylinder from heating up.
Risk of accidents due to supply lines!
During transport, attached supply lines (mains leads, control cables, etc.) can cause
risks, e.g. by causing connected machines to tip over and injure persons!
•
Disconnect all supply lines before transport!
Risk of tipping!
There is a risk of the machine tipping over and injuring persons or being damaged itself
during movement and set up. Tilt resistance is guaranteed up to an angle of 10°
(according to IEC 60974-1).
•
Set up and transport the machine on level, solid ground.
•
Secure add-on parts using suitable equipment.
The units are designed for operation in an upright position!
Operation in non-permissible positions can cause equipment damage.
•
Only transport and operate in an upright position!
Accessory components and the power source itself can be damaged by incorrect connection!
•
Only insert and lock accessory components into the relevant connection socket when the
machine is switched off.
•
Comprehensive descriptions can be found in the operating instructions for the relevant
accessory components.
•
Accessory components are detected automatically after the power source is switched on.
Protective dust caps protect the connection sockets and therefore the machine against dirt and
damage.
•
The protective dust cap must be fitted if there is no accessory component being operated on
that connection.
•
The cap must be replaced if faulty or if lost!
12
WARNING
CAUTION
099-005425-EW501
14.07.2016