Front Panel Features; Ir Learning Receiver - Extron electronics IPCP Pro 250 User Manual

Front Panel Features

Front panel features are shown below. The quantity and location of ports and corresponding
front panel LEDs differ among IPCP models. However, the functions of each type of port
and their LEDs are identical for all models. Most of the features and LED indications are
described and shown in the
the descriptions of the corresponding rear panel ports.
IPCP Pro 350M
(within another device)
RTS
eBUS
CTS
S LIMIT
Tx
Rx
OVER
eBUS
LEDs
eBUS
S LIMIT
R
OVER
Reset Button
(recessed)
R
Reset Switched
Power Button
LED
(recessed)
R
Figure 6.

IR Learning Receiver

In most cases, Extron has already produced a driver file for controlling the projector, display,
or source device you plan to use. If a device driver file is not available, you can create your
own using Extron IR Learner software, the remote control of the projector or display, and the
IR learning receiver sensor on the IPCP, shown the figure above.
Rear Panel Features and Connections
COM
IR/S I/O RELAYS
1 1 2 1 2
1 2 3 2 3 4 3 4
COM IR/ Flex Relay
(Serial) Serial I/O LEDs
LEDs LEDs LEDs
IPCP PRO 250
COM
RTS
IR/S I/O RELAYS
1000
CTS
1 2 1
LINK
IR
Tx
ACT
Rx
1 2 3 4 2
IR Receiver
eBUS LEDs
COM
RTS
eBUS
CTS
S LIMIT
Tx
Rx
OVER 1 2 3
12 VDC COM (Serial)
LEDs LEDs
COM
SWITCHED
12 VDC
1 2 LIMIT
Tx
Rx
3 4 OVER 1 2 3 4 5 6 7 8
NOTE: Numbers adjacent to LEDs correspond
to the like-numbered rear panel ports.
IPCP Pro Series Front Panels
NOTES:
• The Reset button and power LED for the
IPCP Pro 350M are located next to the
rear panel connectors.
• For reset mode information, see
Resetting the Unit
The control processor must be set up
in order to function. See the
based Configuration and Control
section starting on page 25 and
the Global Configurator Help file for
information about Global Configurator,
LAN/
which you must use to set up the unit.
Network
LEDs
Digital I/O LEDs
IR/S I/O RELAYS
1 1 2 1 2
2 3 4 3 4
IR/Serial Relay Flex I/O
LEDs LEDs LEDs
RTS
IR/SERIAL RELAYS FLEX
I/O
CTS
1 2 3 4 1 2 3 4 1
Tx
Rx
5 6 7 8 5 6 7 8 3 4
IPCP Pro Series • Hardware Features and Installation
section paired with
on page 22.
Software-
IPCP PRO 350
LAN
1 2 3
1000
LINK
IR
ACT
IR Receiver LAN/
Network
eBUS LEDs
LEDs
IPCP PRO 550
eBUS
1000
2 S LIMIT
LINK
IR
ACT
OVER
IR Receiver
IR Learning Angle
and Distance
2–12"
(4–30 cm)
1 2 3
4 5 6
7 8 9
0
10