Test And Troubleshoot; Network Communication Setup - Extron electronics IPCP Pro 250 User Manual

…
…

Test and Troubleshoot

…
…

Network Communication Setup

Network setup is essential prior to configuration. Use the flowchart as a guide to setting up
the control processor for network use.
Figure 5.
Save and build the project.
Upload the system configuration to the control processor.
Test the system. See the Troubleshooting
of items to check during system troubleshooting.
Make adjustments to wiring or configuration as needed.
Network Communication Setup,
Connected/Online Method
Connect the control processor and PC to the same LAN
and apply power.
Open the Toolbelt software either from within
Global Con gurator (GC Professional or GC Plus mode)
or from the stand-alone application.
ToolBelt displays a list of all IP Link Pro devices
connected to the network.
Using the MAC address, locate the desired device
in the list and select it.
Enable DHCP or you must type in the
IP address, subnet address, and gateway,
then con gure other network settings as needed.
Network Setup, Online Method
section starting on page 30 for an outline
IPCP Pro Series • Hardware Features and Installation 9