Electrolux EOAP5803A Manual page 37

Problem
The oven does not heat up. The automatic switch-off is
The oven does not heat up. The Child Lock is on.
The oven does not heat up. The door is not closed cor-
The oven does not heat up. The fuse is blown.
The lamp does not operate. The lamp is defective.
The display shows F111.
The display shows an error
code that is not in this ta-
ble.
Steam and condensation
settle on the food and in the
cavity of the oven.
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is on
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible cause
activated.
rectly.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the
socket.
There is an electrical fault.
You left the dish in the oven
for too long.
the front frame of the appliance cavity. Do
not remove the rating plate from the
appliance cavity.
.........................................
.........................................
.........................................
ENGLISH
Remedy
Refer to "Automatic switch-
off".
Refer to "Using the Child
Lock".
Fully close the door.
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Put the plug of the core
temperature sensor as far
as possible into the socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, con-
tact the Customer Care
Department.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing process ends.
37