Electrolux EOAP5803A Manual page 35

The catalytic cleaning
procedure cannot start:
• If you do not remove the
shelf support or telescopic
shelf runners (if present).
• if you did not fully close
the oven door.
Spots or discolouration of the
catalytic surface have no
effect on catalytic properties.
During the catalytic cleaning the oven
lamp is on.
1. In the main menu select the
function:Catalysis
2. Press to confirm.
The display shows the time of day and the
duration of the cleaning procedure (1
hour). You cannot change the duration,
but you can delay the start of the cleaning
procedure with the function: End Time.
When the oven is at the set
temperature, the door locks.
An acoustic signal sounds after the time
ends. The appliance deactivates.
3. Touch a sensor field or open the oven
door to stop the signal.
4. Wipe the bottom of the appliance with
a soft and moist sponge.
12.4 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of
glass panels is different for different
models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
This is to prevent scratches.
6. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
2
B
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them up
out of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install the
glass panels and the door. Do the above
steps in the opposite sequence. Install the
smaller panel first, then the larger.
ENGLISH 35
A
1