Makita HM1317C Technical Information page 19

W
iring diagram
Fig. D-3
Side view of Controller
cover complete
Correct
Connecting
Switch
terminal
Controller cover complete
Do not protrude Connecting terminals
over Controller cover complete toward
Handle assembling side.
Insert Carbon brush into Brush holder as the left illustration in Fig. D-4.
Fig. D-4
Brush holder unit
Pig tail
Insert Carbon brush into Brush holder
so that the pigtail connected portion faces
Motor.
Wiring on Controller cover complete
viewed from Handle side
Wrong
Connecting
terminal
Wiring of Carbon Brush
Correct
Motor housing
Switch lever
Switch
Connecting terminal
Motor housing
side
Motor housing
Brush holder unit
Rear cover
side
Do not face the pigtail connected portion to
Rear cover side when inserting Carbon brush
into Brush holder.
Sponge
Put Controller's lead wire into
the slit of Sponge.
Do not pinch Lead wires
around designated areas.
Wrong
Pigtail
P 19/ 19