Flat Washer - Makita HM1317C Technical Information

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-5. Crank section, Gears
ASSEMBLING
(3) Assemble Gear complete section and Motor section as illustrated in Fig. 28.
Note: Do not forget to set two Flat washers 14 in place.
Fig. 28
Flat washer 14 (2pcs.)
Nylon ring 14
Motor section
[3]-6. Motor section
DISASSEMBLING
(1) Separate Handle section and remove Controller and electrical parts as the right illustration in Fig. 4.
(2) Separate Barrel section and Cylinder section as illustrated in Fig. 14.
(3) Disassemble Gear cover and Rear cover as illustrated in Fig. 19.
(4) Separate Motor section from Crank housing complete as illustrated in Fig. 20.
(5) Disassemble Motor section as illustrated in Fig. 29.
Fig. 29
Pull Armature out of Motor
housing.
Do not lose Wave washer 19
and Washer guide 19 in this
step.
Motor housing
Wave washer 19
Armature
Washer guide
ASSEMBLING
Taking the disassembling step in reverse.
Note: Do not forget to mount the following small parts.
* Flat washer 15: between Ball bearing 6203LLU and Fan 80
* Wave washer 19 and Washer guide: Motor housing
Gear complete 31-43
Needle bearing 1813
(2pcs.)
After Inserting two 1R022 into the gap between
Ball bearing 6203LLU and Fan 80, Press Armature
shaft using Arbor press and 1R023.
Ball bearing
6203LLU
Fan 80
1R022
1R022
1R023
Refer to the right illustration in Fig. 29.
Refer to the left illustration in Fig. 29.
P 15/ 19
Sealing screw, Ball bearing
6302LLU and Flat washer 15
can be removed from Armature.
Sealing screw
Ball bearing
6302LLU

Flat washer 15

Ball bearing
6000DDW
Ball bearing 6000DDW can
be removed with 1R269.