Makita HM1317C Technical Information page 4

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Controller, Switch
DISASSEMBLING
Controller Section can be replaced as illustrated in Fig. 4.
Fig. 4
1. Separate Handle by removing four M6x30 Hex
socket head bolts and two 4x18 Tapping screws.
2. Separate Controller section by removing two
M4x16 Hex socket head bolts.
M4x16 Hex socket
head bolt (2pcs.)
4x18 Tapping
screw (2pcs.)
ASSEMBLING
Take the disassembling step in reverse.
Note: Do not forget to mount Pin 4 when replacing switch. (Fig. 5)
[3]-2. Tool holder section (HM1307C, HM1317C)
DISASSEMBLING
(1) Tool holder section can be disassembled from Barrel as illustrated in Fig. 6
(2) Tool holder section is can be disassembled as illustrated in Fig. 7.
Fig. 6
1. Remove Handle section
and stand the machine.
2. Remove M8x35 Hex
socket head bolts with
Hex wrench 6 and Pipe.
ASSEMBLING
Take the disassembling step in reverse.
Controller section
Handle
M6x30
Hex socket
Head bolt (4pcs.)
Hex wrench 6
Pipe as
extension bar
3. Remove Strain relief.
Controller, Switch and Power supply cord can
be removed from Controller cover complete.
Controller
cover complete
Strain relief
4x18 Tapping screw
Fig. 5
Switch
Fig. 7
1. Attaching 1R239 or 1R284 to 1R306,
set the 1R306 to Arbor press.
2. Put Tool holder on 1R258.
3. Press the 1R239 or 1R284 with Arbor press.
1R306
1R239 or
1R284
Tool holder 1R258 (2pcs.)
P 4/ 19
Switch
Controller
Power supply cord
Pin 4
Tool retainer sleeve
Compression
spring 17
Tool retainer