Avaya 1120E User Manual page 46

Installing the 1120E IP Deskphone
Figure 12: Cable routing tracks and mounting holes
Method B:
1. Attach the 15-cm (6-inch) CAT5e cable.
2. Position the stand over the mounting rivets, and slide the IP Deskphone down the
3. Replace the stand cover. Ensure that all cables are neatly routed and press the
4. Put the IP Deskphone in the wall-mount position (optional). If you wall-mount your
46 Avaya 1120E IP Deskphone with SIP Software User Guide
wall so that the rivets fit into the slots on the stand, indicated in the preceding figure
— Method B.
stand cover into place until you hear a click.
IP Deskphone, put it in the wall-mount position by holding the Tilt Lever and pressing
the IP Deskphone towards the base until the IP Deskphone is parallel with the base.
Release the Tilt Lever and continue to push the IP Deskphone towards the base
until you hear an audible click. Ensure the IP Deskphone is securely locked in
position.
Note:
To add an Expansion Module for Avaya 1100 Series IP Deskphones, see
Expansion Module for Avaya 1100 Series IP Deskphones (SIP Software) User
Guide (NN43110-301).
Comments? infodev@avaya.com
November 2013