Connecting The Handset; Connecting The Headset (Optional) - Avaya 1120E User Manual

Installing the 1120E IP Deskphone
1. Form a small bend in the cable.
2. Thread the adapter cord through the channels in the stand.
To use PoE, your connected LAN must support PoE. A PoE-enabled LAN delivers power to
your IP Deskphone over the CAT-5 network cable and an AC adapter is not required.
Warning:
If you are connected to a PoE connection do not use the AC power adapter.
To use gigabit Ethernet, you must connect to the LAN through CAT-5e (or later) cables.

Connecting the handset

Use the following procedure to connect the handset to the IP Deskphone.
1. Connect the end of the handset cable with a short straight section to the handset.
2. Connect the end of the handset cable with the long straight section, into the RJ-9
3. Form a small bend in the cable.
4. Thread the handset cord through the channels in the stand so that it exits behind

Connecting the headset (optional)

Use the following procedure to connect the optional headset to the IP Deskphone.
1. On the back of the IP Deskphone, plug the headset connector into the RJ-9 headset
2. Thread the headset cord, along with the handset cord, through the channels in the
42 Avaya 1120E IP Deskphone with SIP Software User Guide
handset jack marked with the handset symbol on the back of the IP Deskphone.
The handset symbol is as follows:
the handset on the right side, using the handset cord exit in the stand base marked
with the handset symbol.
jack marked with the headset symbol.
The headset symbol is as follows:
stand so that the headset cord exits the channel marked with the headset symbol.
Comments? infodev@avaya.com
November 2013