Connecting The Handset; Connecting The Headset (Optional) - Avaya 1220 User Manual

Using your Avaya 1220 IP Deskphone
If you insert the foot stand into the lower slots, your Avaya 1220 IP
Deskphone sits at a 55-degree angle.
1. Align the bottom tabs on the foot stand with the position 1 slots or the
position 2 slots on the back of your Avaya 1220 IP Deskphone.
In position 1, the Avaya 1220 IP Deskphone sits at a 25-degree
angle.
In position 2, the Avaya 1220 IP Deskphone sits at a 55-degree
angle.
Figure 8 on page 45
Deskphone.
2. Press the foot stand into the slots until it snaps into place.
Note: If you mount your Avaya 1220 IP Deskphone on a wall, do not
attach the foot stand.

Connecting the handset

Use the following procedure to connect the handset to your Avaya 1220
IP Deskphone
1. Plug the end of the handset cord with the short straight section into
the handset.
2. Plug the other end of the handset cord with the long straight section
into the handset jack marked with the handset symbol as shown
Figure 8 on page
3. (Optional) Thread the cord through the channel in the foot stand (if
installed) so that it exits on the side of the foot stand.

Connecting the headset (optional)

If you have a headset, you can connect the headset to the Avaya 1220 IP
Deskphone as given in the following procedure:
1. Plug the headset cord into the headset jack on the back of the Avaya
1220 IP Deskphone as shown in
2. Thread the cord through the channel in the side of the foot stand (if
installed).
46
shows the slots on the back of the IP
45.
Figure 8 on page 45.