IBM Advanced SerialRAID/X Installation Manual page 24

This section describes how to install the device driver. You must have either
downloaded an updated Windows NT device driver from the SSA World Wide Web
Support page, or have the diskette labeled Windows NT Device Drivers that is provided
with your adapter.
The following steps describe how to install the device driver:
1. Select Start, select Settings, select Control Panel, double click on SCSI
2. Select the Drivers tab, and click Add
3. When prompted, click Have Disk and insert the Windows NT device drivers
4. Select IBM Advanced SerialRAID/X Adapter from the list that appears even if you
5. When finished you will be prompted to restart your computer. Click OK
6. When the system unit restarts, install the host software as described below.
Installing the Host Software
Note: It is assumed you have Windows NT Server 4.0 installed and running on the
1. Insert the CD-ROM provided. Go to Start and select Run. Enter the following
2. The setup program will proceed as follows:
|
|
12
IBM Advanced SerialRAID/X Adapter: Installation Guide
Adapters.
diskette.
Note: Windows NT Server 4.0 may ask you for the path a second time. Enter a:\
again.
have any other SSA adapters installed in the machine.
your system unit, that you have already installed the IBM Advanced
SerialRAID/X Adapter in the system unit and have installed the appropriate
device driver. Windows NT Networking must also be installed, including the
TCP/IP protocol if installing the stand-alone version of RSM.
<cd>:\nt\setup.exe
Where <cd> is your CD-ROM drive letter.
a. Look for the device driver on the system and exit if not found.
b. Select the type of installation, either Automatic or Custom. If installing for the
first time, you should select Custom.
c. Look for existing software components.
d. Inform you of what needs to be updated and what is at the latest level. You can
choose to install any component even if you have the latest level, or wish to
downgrade.
e. Update the host software as necessary.
f. Launch Adobe Acrobat Reader Setup (if required).
Note: Setup must stop running services before updating the program files; you will
be prompted if setup needs to stop a service. If the subsequent file copy
fails, the service may have failed to stop. Follow the instructions in "Checking
the SSA Services Status" on page 17, but click Stop instead of Start and
re-run setup.