.
is the resume button.
Important
If you want to switch the slave device to the main device, please click
main device. You can see the following prompt. See Figure 4-108.
After the master device becomes active again, system can forward the record files on the slave device
to the master device.
4.8.6.4 Cluster control
From main menu->Setup->Cluster service->Cluster control, you can go to the cluster control interface.
It is to enable/disable cluster. See Figure 4-109.
You can see the corresponding prompt if you successfully enabled cluster service.
4.8.6.5 DCS Log
From main menu->Setup->Cluster service->DCS log, you can go to the DCS log interface.
The DCS log interface is shown as in Figure 4-110. Here you can search and view the DCS log.
Figure 4-108
Figure 4-109
button manually to resume the
197